Reading Out The Number Of Cleaning Cycles; Cleaning Cycles In 24 Hours; Total Cleaning Cycles; Loading Default Settings - Oase ProfiClear Premium TF-XL Instrucciones De Uso

- EN -
6.6

Reading out the number of cleaning cycles

6.6.1

Cleaning cycles in 24 hours

Proceed as follows
Press and
6.6.2

Total cleaning cycles

Proceed as follows
Press and
6.7

Loading default settings

Proceed as follows
Press and
in the display.
74
Information
The sum of the automatic and time-dependent cleaning cycles is
for 5 s.
saved. The 4-digit value is displayed in groups of two digits that ap-
pear in succession in the display.
Example:
01-17: Represents 117 cleaning cycles
The number is repeated five times after an extended pause to make it
easier to read:
01-17---01-17---01-17---01-17---01-17
Note:
If the mains voltage is switched off, the counter is reset to 0.
Note:
Due to the self-test of the filter system very different values may be
displayed. The self-test monitors the automatic cleaning process. The
test is carried out continuously in a 2 × 24 hour cycle. The test is only
active from a water temperature >12 °C.
• First 24 hour cycle
− If at least one automatic cleaning process is detected, the cycle is
repeated after the cleaning process has finished.
− If no automatic cleaning process is detected, the second 24 hour
cycle starts once the first has finished.
• Second 24 hour cycle
− The time-dependent cleaning cycle is deactivated. This reduces
the number of cleaning cycles.
− If at least one automatic cleaning process is detected, the first 24
hour cycle starts again once the cycle has finished.
− If no automatic cleaning process is detected, the system message
Er22 is triggered at the end of the cycle. The time-dependent clean-
ing cycle starts again. If an automatic cleaning process is then de-
tected, the first 24 hour cycle starts again. The system message
Er22 is automatically reset.
Information
The sum of the automatic, manual and time-dependent cleaning cy-
for 5 s.
cles is saved. The 8-digit value is displayed in groups of two digits that
appear in succession in the display.
Example:
00-00-12-44: Represents 1244 cleaning cycles
The number is repeated four times after an extended pause to make it
easier to read:
00-00-12-44---00-00-12-44---00-00-12-44---00-00-12-44
Note:
If the mains voltage is switched off, the number of cycles is rounded
off to the nearest hundred and saved.
Information
All individually set values are overwritten!
for 10 s until rE appears
The following values are set:
• Cleaning time CL: 10 s
• Extended cleaning time EC: 20 s
• Interval of the time-dependent cleaning In: 20 min
• Interval Extra Cleaning IE: Every 20 rinsing cycles