Emergency Stop - PLASTITALIA I Plast 105 Manual Del Usuario

14.1.2) Emergency Stop

If necessary, at any time during use you can cause an emergency stop by pressing the on / off button to the OFF
position, or by pressing the STOP button.
Having pressed the on / off button to the OFF position (in any case after disconnecting the control unit from the power
source) after the following restart you will see this message: "Warning, Error, Power interrupted before the end of the
work". Press OK button to proceed and the display shows:
Having pressed the STOP button, you will see this message: "Error, STOP command! Welding Failed ". Press the OK
button to proceed and the display shows:
14.1.3) Reset
Reset Procedure to do after pressing the on / off button in the OFF position
•
Unplug the fitting from the control box terminals (change or wait until the fitting is cool before another fusion
cycle; let pass the cooling time indicated on the fitting)
•
Press START to activate the main screen
Reset Procedure to do after pressing the STOP button
• Unplug the fitting from the control box terminals (change or wait until the fitting is cool before another fusion
cycle; let pass the cooling time indicated on the fitting)
14.2) Fusion start-up
14.2.1) Automatic fusion by Bar Code reading
The display shows the highlighted icon COD:
Press the OK button and the display changes
Read the fitting bar code with the scanner
WELD ! 10,48
Pag. 20