PLASTITALIA I Plast 105 Manual Del Usuario página 16

7.4) Accessories
7.4.1) Barcode wand
For the barcode wand's technical features usable on this electronic device, please contact PLASTITALIA service
7.4.2) USB Memory Drive
Can be used memory drive (USB key) normally present on the market. In order to work properly with our device, technical
requirements are:
• ≥ 1 Gbyte memory capacity
• Formatting FAT 16/32
8) Trasporting and handling
ECU shall be transported using the supplied box ( or bulk bag in case of I Plast 30). Do not knock the machine and do not
damage the body. In case of damage or bruising, do not connect to the fusion power supply and contact the service centre. Be
very careful moving ECU. Switch off ECU using the switch (1) before disconnecting to the input voltage.
9) Storage
If possible, ECU have to be preserved in its supplied box or bulk bag. Avoid exposure to temperatures above 60 ° C and lower
than - 20 ° C. The storage place should be dry, not humid.
10) Disposal
PLASTITALIA obtained the Certification of its own Environmental Management System in conformity to ISO 14000 standards.
Moreover, it is voluntarily registered EMAS Regulation. This ECU and its packaging should be recycled respecting the
environment.
This symbol means: Do not throw the electrical tools in household waste.
According with the European Directives 2002/95/EC and 2002/96/EC - concerning the restriction of hazardous
substances (RoHS) and the treatment of electrical and electronic waste equipment (WEEE) and their application
to national rights - equipment and electrical tools that are no longer usable must be collected separately and
disposed respecting the environment. The owner of this machine must use the disposal method using in its
territory. Please note that there are the presence of aluminum (frame) and copper (transformer) between recyclable materials.
11) Functioning and use
11.1) Intended and non-intended use
This ECU have to be operated by only one qualified operator, educated and informed regarding residual safety risks coming
from its use. The control box is designed to operate in environmental and supply conditions indicated in the table showing
technical data (paragraph 5). It's an electronic device which must be exclusively used to provide the required energy for
electrofusion fittings. The supply circuit must be connected to an electrical system with protection. The electrical circuit
supplying current to the fittings is a PELV (Protected extra low voltage) "low voltage security," and it can be used in areas
defined as "restricted conductors" (eg excavations with presence of humidity). PLASTITALIA is not responsible for any other
use not covered in this handbook.
Pag. 16