Drive Chain Slider - Honda NX4 Falcon Manual Del Propietário

60
Lubrication and Cleaning
Lubricate every 1,000 km (600 miles) or sooner if
chain appears dry.
The drive chain on this motorcycle is equipped with
small O-rings between the link plates. These O-rings
retain grease inside the chain to improve its service
life.
The O-rings in this chain can be damaged by steam
cleaning, high pressure washers, and certain solvents.
Clean the side surfaces of the chain with a dry cloth.
Do not brush the rubber O-rings. Brushing will damage
them. Wipe dry and lubricate only with SAE 80 or 90
gear oil. Commercial chain lubricants may contain
solvents which could damage the rubber O-rings.

Drive Chain Slider

(Refer to the Safety Precautions on page 43.)
Check the chain slider (1) for wear.
The chain slider must be replaced if it is worn to the
bottom of wear limit cutout (2).
For replacement, see your Honda dealer.
(1)
(2)
Owner´s Manual
(1) Chain slider
(2) Cutout