Honda NX4 Falcon Manual Del Propietário página 144

Owner´s Manual
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
(6)
(5) Tang (Speedometer
gear box)
(6) Tang (Right fork leg)
(5)
Rear Wheel Removal
1. Raise the rear wheel off the ground by placing a
support block under the engine.
2. Loosen the drive chain lock nuts (1) and adjusting
nuts (2).
3. Remove the rear axle nut (3) while holding the rear
axle shaft (4) at the end with a wrench.
4. Remove the drive chain from the driven sprocket by
pushing the rear wheel forward.
5. Pull out the rear axle shaft.
6. Remove the rear wheel.
(2)
(2)
(1)
(4) (1)
(1) Drive chain lock nuts
(2) Drive chain adjusting nuts
(3) Rear axle nut
(4) Rear axle shaft
(3)
63