Running-In - Honda NX4 Falcon Manual Del Propietário

Ocultar thumbs Ver también para NX4 Falcon:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Owner´s Manual
Do not open the throttle when starting the engine with
the choke ON. This will lean the mixture, resulting in
hard starting.
3. Immediately after the engine starts, operate the
choke knob (1) to keep fast idle at:
3,000 – 3,500 min
4. About a half minute after the engine starts, push
the choke knob down all the way to Fully OFF (B).
5. If idling is unstable, open the throttle slightly.
High Air Temperature
35°C (95°F) or above
1. Do not use the choke.
2. With the throttle slightly open, press the start button.
Low Air Temperature
10°C (50°F) or below
1. Follow steps 1 – 2 under "Normal Air Temperature."
2. When engine speed begins to pick up, operate the
choke knob to keep fast idle at:
3,000 – 3,500 min
3. Continue warming up the engine until it runs
smoothly and responds to the throttle, when the
choke knob (1) is at Fully OFF (B).
–1
(rpm)
–1
(rpm)
NOTICE
Extended use of the choke may impair piston and
cylinder wall lubrication and damage the engine.
Snapping the throttle or fast idling for more than about
5 minutes at normal air temperature may cause
exhaust pipe discoloration.
Flooded Engine
If the engine fails to start after repeated attempts, it
may be flooded with excess fuel. To clear a flooded
engine, leave the engine stop switch on
push the choke knob down to Fully OFF (B). Open the
throttle fully and crank the engine for 5 seconds. If the
engine starts, quickly close the throttle, then open it
slightly if idling is unstable. If the engine does not start,
wait 10 seconds, then follow the Starting Procedure.

Running-in

Help assure your motorcycle's future reliability and
performance by paying extra attention to how you ride
during the first 500 km (300 miles).
During this period, avoid full-throttle starts and rapid
acceleration.
37
(RUN) and

Hide quick links:

Capítulos

Tabla de contenido
loading

Tabla de contenido