Tabla de contenido
Specifications
411-SDFM85CE
230VAC
411-SDFM11CE
230VAC
Toasters 411-SDFM11CE (11 mm spacer pins for rice
cakes) and 411-SDFM85CE (8.5 mm spacer pins for
pitas) are designed to heat and toast thin product in the
center section between the upper and lower platens.
The 411-SDFM85CE will provide an 8.5 mm center
gap at the -R/Q, R/Q, and +R/Q stop block window
setting while maintaining the standard gap between
base and lower platen at these three settings. This
allows both pitas (in the center section) and chicken
sandwich buns (in the lower section) to use the same
stop block setting. The 411-SDFM11CE will provide an
11 mm gap at all except the _RIB, RIB, and +RIB
settings, but the gap between the base and the lower
platen will not be the same as a standard
411-SDFMCE. Making the conversion in these
instructions will give both toasters the same center and
bottoms gaps as a standard 411-SDFMCE.
Conversion Instructions for
411-SDFM11CE and 411-SDFM85CE
Toasters
If desired, these toasters may be converted to a typical
Big Mac toaster 411-SDFMCE. After conversion the
center gap will vary from 11 to 23 mm depending on
the stop block setting just as it does with older 411
series Big Mac toasters.
To convert to Big Mac toasting, only the upper platen
needs to be moved. Platens must be cool before
converting. It is best to change the two rear studs first.
Then change the two front studs.
Rear studs:
• Raise the front handle to the upper position and latch
the red strap to its mating pin on the handle.
• Support the upper platen at the back so it does not
fall.
• Remove the two upper rear studs.
Printed in USA 4/06 © 2006
3990W
50 HZ
3990W
50 HZ
• Keep and store the two spacer pins in case you wish
• Move the rear studs to the upper holes in the rear
• Mount the rear hexagonal spacers onto the studs.
• Mount the spacer pin mounting brackets onto the
• Screw the studs into the forward holes at the rear of
Front studs:
• Raise the platens to their upper positions and latch
• Support the upper platen at the front so it does not
• Remove the two upper front studs.
• Keep and store the two spacer pins and stud
• Move the front studs to the upper holes in the front
• Mount the front hexagonal spacers onto the studs.
• Mount the spacer pin mounting brackets onto the
• Screw the studs into the forward holes at the front of
The light sensor that begins the timing period has been
adjusted at the factory to work properly at both platen
positions. If, for some reason, it does not work properly
a service agent should adjust it. This adjustment needs
to be done when the toaster is operating and hot. Only
a service agent should do this.
2
to convert back to the 8.5 or 11 mm gaps in the
future.
link.
spacers. These brackets are needed to cover the
vacant holes exposed when the stud is moved.
the upper platen. Tighten studs.
the red strap to its mating pin on the handle.
fall.
bearings in case you wish to convert back to the 8.5
or 11 mm gaps in the future.
handle assembly.
spacers. These brackets are needed to cover the
vacant holes exposed when the stud is moved.
the upper platen. Tighten studs.
411-561revB
Tabla de contenido
