Tabla de contenido
15. Remove the McD
®
NO-SCRATCH™ Pad from the
tool handle and replace it with a clean meshed
grill cloth. The meshed grill cloth should be folded
into a rectangle shape slightly larger than the end
of the tool. Use this to wipe the upper and lower
platen, side bun plates, and clearance blocks
clean. Areas that are difficult to reach can be
wiped with the meshed grill cloth by hand. The
wiping should be continued until all parts are
wiped clean.
TIP: While wiping with the meshed grill cloth, the cloth
must either be frequently replaced or washed and dried.
This will prevent soils from accumulating on the cloth.
16. Use a dry meshed grill cloth to wipe any residual
soil from platens, side bun fence, link and
clearance blocks, and other parts where McD®
Hi-Temp Grill Cleaner was previously applied.
CAUTION: Do not pour water directly onto the heating
platen or use a dripping wet towel. This may cause
water intrusion into the upper and lower heating
platens and could short circuit the grill. This step must
be strictly followed.
17. Wipe platens, side bun fence, and link and
clearance blocks, with a damp (not wet) meshed
grill cloth. After several wipes, the meshed grill
cloth must be cleaned and twisted dry.
Printed in USA 4/06 © 2006
18. To clean the electrical boxes, spray McD
Purpose Super Concentrate onto a dry cloth and
use it to wipe the electrical boxes. DO NOT wipe
the upper and lower electrical boxes with a damp
cloth.
19. Wipe all parts of the machine with a clean
meshed grill cloth and remove any residual debris
from the upper and lower heating platen.
20. Following the completion of the cleaning
procedures discussed above, it is necessary to
dry the grill. Operate the toaster for 30 – 60
minutes in the energy saving position (platens
down).
21. Wipe down surfaces where soils have dripped
during the drying cycle before the grill is used
again.
NOTE: Repeat this procedure to clean additional Rice
Burger Grills. Reverse the McD
and use the clean side.
NOTE: Before using the grill the next morning, inspect
the heating platens to make sure that they have been
thoroughly cleaned and that all grommets and gaskets
on the platen are in good condition to help prevent
grease build-up and migration. Correct any
discrepancy and then install the release sheets.
12
®
All
®
NO-SCRATCH™ Pad
411-561revB
Tabla de contenido
