Tabla de contenido
When
Monthly
Tools
Adjustable Wrench
Flatblade Screwdriver
When
Monthly
Tools
Pliers
Hammer
File
Tighten Platen and Leg Bolts
TIGHTEN PLATEN BOLTS
1.
Turn the power switch to the OFF Position.
2.
Unplug the power cord.
3.
Allow toaster to cool before proceeding.
4.
Using an adjustable wrench, tighten the platen bolts which hold handle in
upright position.
TIGHTEN LEG BOLTS
1.
Carefully turn the toaster upside down for access to legs.
2.
Adjust and tighten leg bolts to obtain a level setting for toasting.
3.
Set toaster right side up and check for level setting.
4.
Adjust leg bolts as necessary until toaster sits level.
5.
Plug the power cord into the appropriate electrical receptacle.
6.
If the toaster is about to be used, turn the power switch to ON position.
Check Bun Tray Platforms, Bun Board, Bun Trays and
Spatulas
IMPORTANT: This check procedure should be conducted while the
platforms, trays and spatulas are cold. It should be done for all spatulas,
trays and platforms.
BUN SPATULA
1.
Lay the spatula on a flat work table top.
2.
Make sure the entire surface is flat, including the front edge. The front end of
bun spatula must be free from necks and burrs.
3.
Sharpen front edge of spatula so all nicks and burrs are removed.
IMPORTANT: Straightening curled corners with pliers and hammer
middle part of the tray flat.
BUN TRAY
1.
Lay the track on a flat work tabletop and inspect for flatness.
2.
Inspect the try for uniform height.
3.
Straightened curled corners with pliers and hammer middle part of the tray
flat.
©2006 McDonald's Corporation
Printed in SEP 2000
Revised in APRIL 2006
Page 5 of 6
Tabla de contenido
