Prince Castle 411-SDFM85CE Serie Manual Del Usuario página 16

Tabla de contenido
13. Apply the McD
®
Hi-Temp Grill Cleaner onto the bun fence on both sides of
the heating platen. Make sure to apply to the blocks at the four top corners of
the upper heating platen. Dip the flat edge of the McD
Pad into the metal container plate and saturate with the McD
Cleaner. Allow the excess to drain into the metal container plate. Do not
scrub while applying the McD
three minute contact time between the McD
surfaces.
14. Lightly scrub all surfaces using the McD
carbon deposits have been removed. Apply additional McD
Cleaner as needed.
15. Remove the McD
®
NO-SCRATCH™ Pad from the tool handle and replace it
with a clean meshed grill cloth. The meshed grill cloth should be folded into
a rectangle shape slightly larger than the end of the tool. Use this to wipe the
upper and lower platen, side bun plates, and clearance blocks clean. Areas
that are difficult to reach can be wiped with the meshed grill cloth by hand.
The wiping should be continued until all parts are wiped clean.
TIP: While wiping with the meshed grill cloth, the cloth must either be
frequently replaced or washed and dried. This will prevent soils from
accumulating on the cloth.
16. Use a dry meshed grill cloth to wipe any residual soil from platens, side bun
fence, link and clearance blocks, and other parts where McD
Cleaner was previously applied.
CAUTION: Do not pour water directly onto the heating platen or use a
dripping wet towel. This may cause water intrusion into the upper and
lower heating platens and could short circuit the grill. This step must be
strictly followed.
17. Wipe platens, side bun fence, and link and clearance blocks, with a damp
(not wet) meshed grill cloth. After several wipes, the meshed grill cloth must
be cleaned and twisted dry.
18. To clean the electrical boxes, spray McD
onto a dry cloth and use it to wipe the electrical boxes. DO NOT wipe the
upper and lower electrical boxes with a damp cloth.
19. Wipe all parts of the machine with a clean meshed grill cloth and remove any
residual debris from the upper and lower heating platen.
20. Following the completion of the cleaning procedures discussed above, it is
necessary to dry the grill. Operate the toaster for 30 – 60 minutes in the
energy saving position (platens down).
21. Wipe down surfaces where soils have dripped during the drying cycle before
the grill is used again.
NOTE: Repeat this procedure to clean additional Rice Burger Grills.
Reverse the McD
®
NO-SCRATCH™ Pad and use the clean side.
NOTE: Before using the grill the next morning, inspect the heating
platens to make sure that they have been thoroughly cleaned and that all
grommets and gaskets on the platen are in good condition to help
prevent grease build-up and migration. Correct any discrepancy and
then install the release sheets.
®
NO-SCRATCH™
®
Hi-Temp Grill Cleaner. Allow at least a
®
Hi-Temp Grill Cleaner and the
®
NO-SCRATCH™ Pad until all
®
®
All Purpose Super Concentrate
©2006 McDonald's Corporation
Printed in SEP 2000
Revised in APRIL 2006
®
Hi-Temp Grill
Hi-Temp Grill
®
Hi-Temp Grill
Page 4 of 6
Tabla de contenido
loading

Productos relacionados para Prince Castle 411-SDFM85CE Serie

Este manual también es adecuado para:

411-sdfm11ce serie

Tabla de contenido