Tabla de contenido
Area 51
!2%! $!3("/!2$ 02/",%- 3/,54)/.
INDICATOR CHECK (DISPLAY)
Point Item
1
General.
2
Initial check, see p.
180.
3
Speed.
4
Fuel level.
(*) = In cases like these, change the dashboard with a perfectly working one and repeat the tests.
Defect
Check
No signal.
Ignition switch.
n
m
"
-
Battery.
Wiring connec-
tors.
Initial check doesn't
Front wheel.
work.
Low beam warning
No check.
b
light "
" (high beam
a
warning light "
"
C % K _
) and
direction indicator
warning light do not
come on.
Instrument always
Connector,
speed sensor,
indicates speed "
".
wiring.
Indicated speed is
too different from
(*)
actual speed.
Speed indicator
(*)
unstable.
Fuel level indicator
Connector, fuel
always indicates
level sensor, wir-
"empty".
ing.
Fuel level indicator
Fuel level sen-
always indicates
sor, wiring.
"full".
Indicated fuel level
No defect.
does not change
quickly.
Possible cause
Ignition key in wrong position.
s
-
"
Insufficient battery charge. Insuffi-
cient contact/ disconnected termi-
nals, burnt fuse.
Disconnected connectors/insuffi-
cient contact, interrupted wiring.
Initial check does not work if front
wheel is turning.
No defect, since only two warning
g
lights (fuel level "
" and mixer oil
j
reserve "
") come on during
check.
Disconnected connector/insufficient
contact/interrupted wiring, faulty sen-
sor, wiring squashed in the frame.
(*)
(*)
Disconnected connector/insufficient
contact/interrupted wiring, faulty fuel
level sensor.
Faulty fuel level sensor (internal short
circuit), wiring squashed in the frame.
Level change (from one segment of
the display to the successive one)
takes twenty-five seconds (max.).
194
Remedy
Turn ignition key to posi-
m
tion "
" and make sure
dashboard comes on cor-
rectly, see point 2.
– If dashboard does not
come on, check: bat-
tery, connectors and
wiring, see below.
– If dashboard comes on,
inform owner that when
ignition key is turned to
position " ", dashboard
goes out completely (no
indicator remains on).
Charge or replace battery.
Reconnect terminals,
change fuse.
Reconnect/repair/change
connectors, change wiring.
Turn ignition switch to posi-
n
tion "
" while front wheel
is not turning.
Inform owner.
Reconnect/repair/change
connector, check/change
sensor, repair/change wir-
ing.
(*)
(*)
Reconnect/repair/change
connector, check/change
fuel level sensor, repair/
change wiring.
Check/change fuel level
sensor, repair/change wir-
ing.
Inform owner.
Tabla de contenido
