nicai systems FT210B Instrucciones Y Advertencias Para El Instalador página 7

3.2) Fixing of the devices
Perform the installation and fixing of the devices following the operations below:
1. To separate the electronic board from the base, use a screwdriver to lever the three clips as indicated in fig. 13.
2. Fix the receiver as shown in fig. 14.
3. Assemble the transmitter on the mobile leaf as shown in figure 15.
13
4. Connect the 8.2KΩ constant resistance type sensitive edge on the transmitter as shown in figure 16. The resistance on the
TX terminals is removed and used as a termination on the sensitive edge or does not need to be used if the sensitive edge
already has a terminating resistance.
16
If the sensitive edge has an output with 2 separate NC contacts, it can be connected as shown in figure 17 placing the 8.2KΩ
resistance in series between the two contacts. Make sure that the sensitive edge complies with the failsafe category 3 accord-
ing to the EN 954-1 standard.
Warning: do not use sensitive edges
that have only one NC type contact
because they do not have the necessary
failsafe category required by the said
standard.
5. Carry out the "BlueBUS" electrical
connections on the receiver following
that which is indicated in the control
unit instructions manual.
6. Direct the lenses as in fig. 18 in order
to obtain the correct alignment
between the TX and RX The correct
alignment will be verified in chapter 4
"Testing".
7. Program the jumpers on both the TX
and RX (see paragraph 19) for the
desired function following that indicat-
ed in tables 2 and 3.
14
17
19
TX
JP1
L
+
JP2
L1
JP3
L2
L3
L4
-
18
RX
JPX
GB
15
BlueBUS
7