Description Of The Control Panel; Introduction; Main Controls; Main Cooking Modes - Rational 6 GN 1/1 Instalación Uso Y Mantenimiento

USA

3. DESCRIPTION OF THE CONTROL PANEL

3.1 INTRODUCTION

To aid understanding of the operation of the oven, find the folding
double page showing the control panel for your model among
those included at the back of this handbook and then open it out
and keep it open while reading this section.
The following headings describe all the functions available on the
various models in the range.
Some functions are shared by all models, others are available
on specific models.

3.2 MAIN CONTROLS

Main switch
Cooking cycle/program start/stop.

3.3 MAIN COOKING MODES

Air-convection cycle: To roast and gratin with a maximum
temperature of 572°F(300°C) (for 10 minutes max, 483°...
572°F)(251...300°C).
Mixed cycle: superheated steam. Uses the oven chamber heaters
and steam generation system at the same time to keep food soft
(maximum temperature 482°F)(250°C).
Steaming cycle: ideal for steam cooking (operating temperature
automatically set at 212°F)(100°C).
You can set low temperature steam for gentle cooking of foods
in vacuum packs and for thawing (temperature from 77°F to
210°F)(25° to 99°C).
Displaying the humidity value: allows you to display the humidity
level of the air-convection, mixed and regeneration cycles.
Digital thermometer/thermostat: to control the temperature in
the oven chamber.
Timer to control cooking time.
Digital thermometer/thermostat: to control product core tem-
perature.

3.4 SPECIAL COOKING MODES

Utilities
Functions useful for the type of cooking to be executed.
Pause phase: set a time in this mode to delay the start of cooking
programs or to set a pause interval between two cooking cycles
(e.g. for dough proving).
Regeneration cycle: gives ideal humidity conditions for rapid
heating of products to be regenerated (maximum temperature
482°F)(250°C).
The regeneration program is composed of a single phase with the
following characteristics:
- a special cycle with controlled humidity of 60 % (adjustable if
required);
- preset temperature of 356°F (180°C)(can be altered if necessary);
- use of maximum power;
- a preset time of 30 minutes (adjustable if required) and once
started, remains active with door open or closed.
DANGER: CAVITY FAN AND STEAM WILL CONTINUE TO
OPERATE WHEN DOOR IS OPEN. WHEN IN
REGENERATION CYCLE. OPEN DOOR SLOWLY TO
AVOID THE RISK OF BURNS.
Alternatively to the set cooking time it can also accept Cont
cooking time or the core probe.
HOLD
Cook and hold cycle: for long slow cooking, typically for meat
large piece of meat for roasting
(
It can be used in combination with convection, mixed, steam
and regeneration modes.
HACCP
HACCP: serves to record the cooking program in compliance with
HACCP standards (Hazard Analysis and Critical Control
Points). Depending on the system requested you can record
cooking data on a dedicated printer or directly on a PC.
Clean Cycle: semiautomatic oven cleaning cycle (see section 7.
CARE AND MAINTENANCE).
20
).