Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 89

7.2. Turn the Buzzer On/Off
Press and hold the On/Off button for 10 seconds.
•
A short beep indicates On.
A flash indicates Off.
7.3. Enable/Disable the Automatic Operation
This option is used to disable (pause) a predefined Automatic Operation of the unit. This option does not prevent
•
Manual Operation (Section 6.3).
•
A red LED will be lit on the Power Box. 'OFF' indication will be displayed on the mower:
If the unit is currently in the process of mowing:
o
To Enable the Automatic Operation
•
Press and hold the On/Off button for 2 seconds.
o
Use P021 menu in Advanced Settings (see Section 6.4.2 for more details).
o
8. Charging
8.1. Charging During the Season
The Base Station is the primary charging source when the unit is docked and will maintain the optimal battery charge
while awaiting departure.
8.2. Charging Out of Season
During out of season months, such as winter, it is required to:
Fully charge the battery in the Base Station till the Battery
•
indicator is green and lit constantly. Note! The Safety
Switch should be in 'On' position during charging.
LED indicators for charging:
Red is lit constantly – Charge the battery.
Green is blinking – During battery charging.
Green is lit constantly – Battery is fully charged.
Remove the unit from its Base Station. Turn the Safety
•
Switch off and store the mower in a room temperature.
If the mower is stored for more than 3 months, it is required
•
to recharge the battery every 3 months till the Battery
indicator shows it is fully charged.
The charging can be done in one of the following options:
•
1. Place the mower in the Base Station for charging.
2. Connect the unit directly to the Power Box as follows:
Disconnect the DC Cable coming from the Power Box
to the 15m Extension Cable and connect it to the rear
side of the mower as shown in the figure to the right.
Once the season starts, just place the unit in its Base Station to begin automatic operation.
•
!IMPORTANT! Always charge your mower in a horizontal position. The mower should be flat on the ground while
connected to the Power supply.
Press and hold the Automatic Operation On/Off button for 2 seconds.
The unit will complete the current mowing cycle.
After completing the current mowing cycle, the unit will stay in the Base Station and will not
start another mowing cycle.