Know Your Unit - Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento

2.

Know Your Unit

2.1. How Your Unit Works for You
First, you need to install a perimeter wire around the entire lawn and
•
around protected areas within the lawn area.
The Perimeter Wire sets the boundaries for the unit. The Perimeter Wire
•
is laid around the edges of the lawn and around trees, plants, ponds
and objects that you want to prevent the unit to run into.
If the supplied wire is not sufficient, more wire can be purchased and
•
spliced with a supplied connector to the existing wire.
Small pegs are used to fasten the Perimeter Wire into the ground,
•
below grass level.
The Perimeter Wire will gradually disappear under the growth of new
•
grass until it will be invisible.
The Base Station is placed along the Perimeter Wire. It performs two
•
basic functions:
Generate a signal along the Perimeter Wire.
•
Charge the unit's batteries.
•
The Power Box is connected between the Base Station and a 230V /
•
120V wall socket, using a 15m (50 ft.) long low voltage cable.
After having completed the installation of the Perimeter Wire, Base
•
Station, and the Power Box, and performing the One-Time Setup [needs to be performed before operating the
unit for the first time – detailed instructions are in the following chapters], the unit will do all the mowing for
you for during the entire season!
The unit is a robotic lawn mower that is powered by a maintenance-free battery. It leaves its Base Station at
•
scheduled mowing times. The unit mows the lawn and then drives back to the Base Station to be charged and
ready for its next scheduled mowing.
As soon as the unit departs for mowing, the Base Station automatically triggers a special signal. This signal
•
creates a virtual wall, visible only to the unit. This signal keeps the unit within the lawn boundaries, and prevents
it from entering areas it was intended to skip or protect.
Base Station and Power Box:
- Generates signal along the wire
- Charges units' battery
Perimeter wire as a virtual wall,
visible only to the unit
Tree surrounded by a groove, dicht or flower beds requires a
wire around it
Large trees: The unit is allowed to bump into them, at this
size, the objets do not require a Perimeter Wire around
them
Perimeter Wire
Peg
The unit detects the signal and
changes direction as it reaches the
wire