Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 63

There are two options to set the Base Station:
3.2.2. Internal Setup (on the lawn perimeter)
• Choose a place along the Perimeter Wire where you
want to place the Base Station, based on the inputs
given in paragraph 3.2.1.
• Place the Base Station in the direction shown in the
figure to the right.
3.2.3. External Setup (off the lawn perimeter):
There are two types of External Setup:
A. At a corner
In this type of setup, the Base Station is located at one of
the corners of the lawn, as shown in the figure at the right.
• Choose a corner where you want to place the Base
Station outside of the lawn area.
• Place the Base Station, where its front side is touching
the lawn edge or placed somewhat on the lawn.
• Continue to lay the perimeter wire as shown in the
figure to the right, where it continues at least 10cm (4")
beyond the Base Station and turns back towards the
lawn at a distance of 10cm (4") from the other wire.
• The Base Station may be placed in a small shift to the
right in order to allow smooth entry of the unit to the
Base Station.
• You will have the opportunity to later adjust the Base
Station position to confirm smooth entry.
B. Outside the lawn
(Can be set only through the unit App for specific
models)
• Choose a place outside the lawn where you want the
unit to dock and charge.
• Confirm the path between the lawn and the outside area
is smooth with no height difference, so the unit will not
get stuck and will follow the wire smoothly.
• The surface between the lawn and the Base Station
should be hard (such as a sidewalk or rigid ground) and
not sandy or stony, so the unit will not slip or get stuck
on it.
• The area between the lawn and the Base Station should
be clear of obstacles and objects.
• Lay the wire as shown in the figure to the right:
Narrow path of 50cm (20") width.
Square Perimeter Island of 30cm (12") edges.
Island starts 50cm from the Perimeter Wire.
Keep a distance of 10cm (4") between Perimeter Wire
and the Island from both sides.
The front of the Base Station should be placed a
minimum distance of 1.5m (5 ft.) from the Perimeter
Wire and NOT more than 4m (13 ft.).
10cm (4'')
Min. 10cm (4'')
Main Zone
Perimeter Island
30°cm
10cm (4'')
10cm (4'')
Min. 1.50m (5ft) – Max 4m (13 ft)
50cm (20'')
50cm (20'')