Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 70

4.3.3. Setting a Narrow Pass
A Narrow Pass is defined as a path that connects two zones of the lawn. The path enables the unit to drive between
the zones while following the wire, but prevents the unit from crossing between them while mowing the inner area of
the zones.
To set up a Narrow Pass follows the instructions given in the figure below:
A. At the point you want the unit to start
driving towards the Sub-Zone start to set
the Narrow Pass.
B. 50 cm (20 inches) from the Narrow Pass
entry, set a Perimeter Island (refer to 4.2.4)
of 30 cm sides (12 inches) at a distance of 10
cm (4 inches) from the Perimeter Wire.
C. Continue to lay the wire towards the Sub-
Zone and lay another Island with the same
dimensions, 50 cm (20 inches) from the
Sub-Zone Perimeter Wire.
D. After completing the setup of the wire in
the Sub-Zone, make sure you keep 10 cm (4
inches) between the wire and the islands on
the way back to the Main Zone.
The above setup allows the unit to drive along the wire to reach the Sub-Zone. However, while mowing each zone
individually, it will not cross over to the other zone.
Sub-Zone
Main Zone
Perimeter Island
30x30c
Perimeter Island
30x30c