Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 100

11.6. Splicing the Perimeter Wire
If the Perimeter Wire needs to be spliced, use the connectors
supplied in the unit box. It is waterproof and gives a reliable electrical
connection.
IMPORTANT! Before slicing the Perimeter Wire, disconnect the
Power Box from the power outlet.
1. Strip 1 cm (0.5 inch) of each wire end together and twist the
stripped ends using pliers.
2. Insert the twisted wires into the splicing connector.
3. Screw the wire connector on the twisted wires. Make sure it is
tightly secured.
IMPORTANT! Neither twisted cables, nor a screw terminal insulated
with insulation tape are a satisfactory splice. Soil moisture will cause
such conductors to oxidize and will later lead to a broken circuit.
11.7. Maintenance of the Base Station Area
Keep the Base Station entrance and area clean of leaves, sticks,
•
twigs or any other debris that usually accumulates in such areas.
NEVER spray a water hose directly towards the Base Station.
•
Be careful when trimming around the Base Station with a
•
powered weed trimmer as damage to the Extension Cable may
occur.
In the event of damage to any part of the Extension Cable, stop
•
the use of the mower and the Base Station. Disconnect the
Extension Cable and replace it.
11.8. Lightning storm
To reduce the risk of damage to components in the case of a lightning
storm, disconnect the Perimeter Wire from the Base Station /Perimeter
Switch and the Power Box 230V/120V plug from the power outlet.
Wire
Connector