Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 73

After the Base Station has been positioned, insert 2 stakes into the
o
Base Station holes as shown in the figure to the right. Only after the
Base Station position has been tested during the One-Time Setup
process (see Section 5.2), you will be able to insert the remaining two
stakes.
4.7. Connecting the Power Box
In order to find a proper location for the Power Box, please refer to Section 3.3.
For the Power Box installation instructions please refer to Section 4.1.2.
Laying and Fastening Extension Cable
4.7.1. At the Power Box Location:
Connect the DC Cable from the Power Box to the 15 m (50 ft.)
•
Extension Cable.
Connect the Power Box to a regular power outlet (230V / 120V).
•
Safety – Avoid injury!
The Extension Cable from the Power Box to the Base Station should
be securely fastened to the ground! It should never present a
tripping hazard.
The Extension Cable should cross ONLY over soft surfaces.
It should not cross over hard surfaces (e.g. Sidewalk, driveway)
where it cannot be securely fastened.
The Docking Indicator (1) will light up if the mower
•
is in the Base Station.
The Operating Indicator (3) will light up if the
•
mower is not in the Base Station.
Automatic Operator
Docking Indicator
On/Off Button
Operating Indicator
Wire Indicator