Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 79

5.2.6. Test Wire Position
U003 is displayed (Test Wire Position) – press OK.
•
The unit will follow the wire along the edge to test the wire
•
position.
Walk alongside the mower while it is following the edge.
Having completed the process, the unit will enter the Base
Station and the setup process will be completed.
If the unit collides with obstacles along the
edge, the mower will stop and drive
backwards with ' U052' (Adjust Wire)
displayed:
• Move the wire slightly inward.
If, at any point, you wish the mower to drive closer to
•
the edge to enlarge the covered area, press Stop
('U003' is displayed - Test Wire Position):
- Move the wire slightly outward.
- Place the mower in front of the changed section of
wire.
- Press OK to continue the 'Test Wire Position'
process.
If you want to quit the setup process, press and hold
•
the STOP button for 3 seconds. The screen will change
to the Main Display (current time).
After completing the Test Wire Position, test the
•
mower in Near Wire Follow mode to confirm it
completes the drive near the wire smoothly, without
acquiring any adjacent wire or hitting any obstacle on
its way to the Base Station.
If the mower fails to complete the Near Wire Follow
•
smoothly to the Base Station, then reduce the Near
Wire Follow Distance (Menu P004) and repeat the test
until it will complete the drive smoothly.
!IMPORTANT! To restart the One-Time Setup process press and hold STOP + Setting + Left arrow buttons together
for more than 4 seconds. This will invoke Factory Defaults ("Out of the Box" settings).
5.2.7. After Setup is Completed
Once the wire setup is complete, drive additional pegs at a
distance of approximately 0.75 m (2.5 ft.) apart.
Use additional pegs in areas where there are bumps or
•
dips in the lawn.
If needed, purchase extra pegs.
Inspect the wire installation for tripping hazards.
•