Thermor IAC/S 300 Instrucciones De Instalacion Y De Uso página 4

WARNING: Heavy product must be handled with care:
I. Install the device in a room protected against freezing. Any
damage to the device due to overpressure resulting from
blocking the safety unit is not covered by the warranty.
II. Make sure the wall can support the weight of the device filled
with water.
III. If the device must be installed in a room or a location where the
ambient temperature is constantly above 35°C, provide
ventilation in this room.
IV. Do not install this product in
volumes V0, V1 and V2 in a
bathroom. If the dimensions
do not allow it, it can
nevertheless be installed in
volume V2 (see figure on
the right).
V. Install the device in an
accessible location.
VI. Refer to installation figures in the "installation" section.
VII. This device
2,000 meters above sea level.
Installing a wall-hung vertical heater: For installing or replacing
some heating elements, leave a clearance of 500 mm underneath
the water heater pipe ends.
A drain pan must be installed under the water heater when it is
installed on a false ceiling, in an attic or above inhabited dwellings.
A drain connected to the sewer is required.
Réf doc : U0570659_#
INSTALLATION
is not intended to be installed above
Page 4/ 220