Livestrong LSPRO1 Manual Del Propietário página 9

LSPRO2 ASSEMBLY STEP 1
HARDWARE FOR STEP 1 :
BOLT (A)
LSPRO 2 SPRING WASHER (B)
20 mm 8.2 mm
Qty: 6 Qty: 6
RIGHT CONSOLE MAST
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
16
LSPRO1and2_OM_Rev1_9.indd 16-17
A Open HARDWARE FOR STEP 1.
B Pull LEAD WIRE through RIGHT CONSOLE MAST.
ARC WASHER (C) After pulling the LEAD WIRE through the mast, the
8.4 mm
top of the CONSOLE CABLE should be located at
Qty: 6
the top of the mast. Detach and discard LEAD WIRE.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
C Place RIGHT CONSOLE MAST over MAIN FRAME
LEAD WIRE
BRACKET.
CONSOLE CABLE
D Attach CONSOLE MAST to MAIN FRAME
BRACKET using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC WASHERS (C).
NOTE: Do not tighten bolts until step 3 is complete.
E Repeat steps C–D on other side.
LSPRO2 ASSEMBLY STEP 2
HARDWARE FOR STEP 2 :
BOLT (A)
SPRING WASHER (B) FLAT WASHER (D)
20 mm 8.2 mm 8.2 mm
Qty: 6 Qty: 6 Qty: 6
HANDLEBAR CABLE CONSOLE MAST BRACKET
CONSOLE MAST HANDLEBARS
FLAT WASHERS (D)
SPRING WASHERS (B)
BOLTS (A)
Open HARDWARE FOR STEP 2.
A
Feed HANDLEBAR CABLE through
B
CONSOLE MAST BRACKET and out through
the top of CONSOLE MAST.
Slide HANDLEBAR onto CONSOLE MAST
C
BRACKET and attach using 3 BOLTS (A),
3 SPRING WASHERS (B) and 3 FLAT
WASHERS (D).
Repeat on other side.
D
NOTE: Be careful not to pinch any wires
while attaching the handlebars.
8/22/11 4:02 PM
LSPRO 2
17