Livestrong LSPRO1 Manual Del Propietário página 7

LSPRO1 ASSEMBLY STEP 1
HARDWARE FOR STEP 1 :
BOLT (A)
LSPRO 1 SPRING WASHER (B)
20 mm 8.2 mm
Qty: 6 Qty: 6
RIGHT CONSOLE MAST
MAIN FRAME BOOT
LEFT CONSOLE MAST
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
12
LSPRO1and2_OM_Rev1_9.indd 12-13
A Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
ARC WASHER (C)
8.4 mm
B Open HARDWARE FOR STEP 1.
Qty: 6
C Slide MAIN FRAME BOOT up CONSOLE MAST.
Place RIGHT CONSOLE MAST over MAIN FRAME
BRACKET.
D Pull LEAD WIRE through RIGHT CONSOLE MAST.
After pulling the LEAD WIRE through the mast, the
top of the CONSOLE CABLE should be located at
the top of the mast. Detach and discard LEAD WIRE.
LEAD WIRE
CONSOLE CABLE
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
E Attach CONSOLE MAST to MAIN FRAME
BRACKET using 3 BOLTS (A), 3 SPRING
WASHERS (B) and 3 ARC WASHERS (C).
NOTE: Do not tighten bolts until step 3 is complete.
F Slide MAIN FRAME BOOT down over MAIN FRAME
BRACKET.
G Repeat steps D–F on other side.
LSPRO1 ASSEMBLY STEP 2
HARDWARE FOR STEP 2 :
BOLT (A)
SPRING WASHER (B) FLAT WASHER (D)
20 mm 8.2 mm 8.2 mm
Qty: 6 Qty: 6 Qty: 6
HANDLEBAR CABLE HANDLEBARS
CONSOLE MAST
CONSOLE MAST BRACKET
FLAT WASHERS (D)
SPRING WASHERS (B)
BOLTS (A)
Open HARDWARE FOR STEP 2.
A
Feed HANDLEBAR CABLE through
B
CONSOLE MAST BRACKET and out top of
CONSOLE MAST.
Slide HANDLEBAR onto CONSOLE MAST
C
BRACKET and attach using 3 BOLTS (A),
3 SPRING WASHERS (B) and 3 FLAT
WASHERS (D).
Repeat on other side.
D
NOTE: Be careful not to pinch any wires
while attaching the handlebars.
8/22/11 4:01 PM
LSPRO 1
13