Livestrong LSPRO1 Manual Del Propietário página 8

LSPRO1 ASSEMBLY STEP 3
HARDWARE FOR STEP 3 :
BOLT (A)
LSPRO 1 SPRING WASHER (B)
20 mm 8.2 mm
Qty: 6 Qty: 6
CONSOLE &
HANDLEBAR
CABLES
14
LSPRO1and2_OM_Rev1_9.indd 14-15
Open HARDWARE FOR STEP 3.
A
Gently hold the CONSOLE above the
B
ARC WASHER (C)
CONSOLE MASTS.
8.4 mm
Qty: 6
Connect the CONSOLE & HANDLEBAR
C
CABLES, carefully tucking wires in masts to
avoid damage.
Attach each side of the CONSOLE using 3
D
BOLTS (A), 3 SPRING WASHERS (B) and 3
ARC WASHERS (C).
E Fold the deck into the upright position until
CONSOLE the foot latch engages. Rotate the CONSOLE
MASTS until the spacing between the
handlebars and the deck are the same. Tighten
BOLTS from step 1 and then step 3.
ARC WASHERS (C)
SPRING WASHERS (B)
BOLTS (A)
CONSOLE MAST
LSPRO1 ASSEMBLY STEP 4
SCREWS (E) MAIN FRAME BOOT
HARDWARE FOR STEP 4 :
SCREW (E) SCREW (F)
20 mm 15 mm
Qty: 4 Qty: 6
Open HARDWARE FOR STEP 4.
A
B Attach MAIN FRAME BOOTS using 4
SCREWS (E).
C Attach END CAPS using 6 SCREWS (F).
IMPORTANT
This treadmill has a pre-waxed belt and
should never be lubricated or waxed.
Lubricating or waxing the belt can cause
damage that is not covered by the
warranty.
END CAPS
YOU ARE FINISHED!
BOLTS (F)
LSPRO 1
15
8/22/11 4:02 PM