Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LSPRO2 ASSEMBLY STEP 3
HARDWARE FOR STEP 3 :
BOLT (A)
LSPRO
2
SPRING WASHER (B)
20 mm
8.2 mm
Qty: 6
Qty: 6
CONSOLE &
HANDLEBAR
CABLES
18
LSPRO1and2_OM_Rev1_9.indd 18-19
Open HARDWARE FOR STEP 3.
A
Gently hold the CONSOLE above of the
B
ARC WASHER (C)
CONSOLE MASTS.
8.4 mm
Qty: 6
Connect the CONSOLE & HANDLEBAR
C
CABLES, carefully tucking wires in masts to
avoid damage.
Attach each side of the CONSOLE using 3
D
BOLTS (A), 3 SPRING WASHERS (B) and 3
ARC WASHERS (C).
E
Rotate the CONSOLE MASTS until the
CONSOLE
spacing between the handlebars and the deck
are the same. Tighten BOLTS from step 1 and
then step 3.
IMPORTANT
ARC WASHERS (C)
This treadmill has a pre-waxed belt and should
SPRING WASHERS (B)
never be lubricated or waxed. Lubricating or
BOLTS (A)
waxing the belt can cause damage that is not
covered by the warranty.
CONSOLE MAST
YOU ARE FINISHED!
TREADMILL OPERATION
This section explains how to use your treadmill's console and programming. The BASIC OPERATION section in the
TREADMILL GUIDE has instructions for the following:
• LOCATION OF THE TREADMILL
• USING THE SAFETY KEY
• FOLDING THE TREADMILL
• MOVING THE TREADMILL
• LEVELING THE TREADMILL
• TENSIONING THE RUNNING BELT
• CENTERING THE RUNNING BELT
• USING THE HEART RATE FUNCTION
19
8/22/11 4:02 PM
Tabla de contenido
