Ingersoll Rand EMX60 Manual De Operación Y Mantenimiento página 5

Switch Action:
To start the tool, simply squeeze the switch lever. Release
the switch lever to stop the tool. See Figure 4.
- Figure 4 -
Blows per minute
Amps (115V)
Length without accessory
Weight without accessory
Chuck size
INSTALLATION (Continued)
SPECIFICATIONS
Table 2: Specifications
MODEL EMX60 PAVING BREAKER
5
Operation:
Hold the tool firmly with both hands. Turn the tool on and
apply slight pressure on the tool so that the tool will not
bounce around, uncontrolled. Pressing very hard on the tool
will not increase the efficiency.
In cold weather or when the tool has not been used for a long
time, let the tool warm up for several minutes by operating it
under no load. This will loosen up the lubrication. Without
proper warm-up, hammering operation is difficult
Never operate the tool unless a bit is properly installed
and tool is held firmly against the work. Do not operate
tool with broken or damaged parts.
1000
15.0 A
32-1/4"
64 lbs
1-1/8" Hex. Shank