Battery Service - Westinghouse PRO Serie Manual Del Propietário

Figure 55 – Removing Spark Plug – 8KPRO
6. Place a clean rag over the opening created by the
removal of the spark plug to make sure no dirt can
get into the combustion chamber.
7. Inspect the spark plug for:
Cracked or chipped insulator
Excessive wear
Spark plug gap (the acceptable limit of 0.024 –
0.032 in. [0.60 – 0.80 mm]) (see Figure 56).
If the spark plug fails any one of the conditions
listed above, replace the plug with a Champion
RN9YC plug or equivalent.
NOTICE
Only use the recommended spark plug (Champion
RN9YC or equivalent). Using a non-recommended
spark plug could result in damage to the engine.
Figure 56 – Spark Plug Gap Requirements
MAINTENANCE
8. Install the spark plug by carefully following the steps
outlined below:
a - Carefully insert the spark plug back into the
cylinder head. Hand-thread the spark plug until
it bottoms out.
b -
Using the 13/16" spark plug socket wrench
provided, turn the spark plug to ensure it is fully
seated.
c - Replace the spark plug boot, making sure the
boot fully engages the spark plug's tip.
Recommended Spark Plug Replacement:
AutoLite
Champion
Bosch
Torch

BATTERY SERVICE

To ensure the battery remains charged, the generator
should be started every 2 to 3 months and run for
a minimum of 15 minutes or the charger should be
plugged into the generator and the generator should be
charged overnight. Plug the cord from the charger into
the charging port on the generator. Plug the charger into
a 110/120-volt AC outlet (see Figure
Figure 57 – 120-Volt AC Charger
63
RN9YC
WR7DS
F6RTC
57).
43