Sony UPX-2000 Manual De Instrucciones página 54

Troubleshooting
54
Error messages on the LCD of the station
If a problem occurs, the POWER/BUSY lamp on the station lights in red
and an error message stating the problem appears on the LCD of the
station.
Message in Possible causes/Action
the station's LCD
CHECK RIBBON • The ink ribbon cartridge is defective.
n Replace the defective ink ribbon cartridge with the
new one.
• The ink ribbon has torn.
n Repair the tear. (page 25)
• The ink ribbon cartridge that can not be used with this
printer has been loaded.
n Load the appropriate ink ribbon cartridge.
PAPER JAMMING The paper has jammed inside the printer.
n Refer to the insert entitled "If the Paper Jams."
SENSOR TROUBLE Sensor trouble has occurred.
n The printer must not be operated any further. Turn
off the power immediately and contact your Sony
service facility or your Sony dealer.
END OF RIBBON The ink ribbon has been exhausted.
n Replace the old one with a new ink ribbon cartridge.
(page 22)
(The ink ribbon cannot be reused.)
INSERT RIBBON The ink ribbon cartridge is not loaded.
n Load the ink ribbon cartridge. (page 22)
SET PAPER • Paper has been exhausted.
n Load the paper. (page 25)
• The paper tray is not installed.
n Install the paper tray. (page 25)
INSERT RIBBON The ink ribbon cartridge and paper are not loaded.
SET PAPER n Load the ink ribbon cartridge and paper.
(pages 22 through 27)
REMOVE PRINTS The maximum number of printouts has accumulated on
the paper cover.
n Remove the printouts from the paper cover.
REMOVE PAPER The paper jams around the paper tray as it is being fed
into the ribbon area.
n Refer to the insert entitled "If the Paper Jams."
CLOSE COVER The top cover opens.
n Close the top cover.
SET CAMERA The camera is not connected correctly or the camera is
not turned on.
n Connect the camera correctly (pages 29 and 30),
set the PLAY/CAMERA/OFF switch of the camera to
PLAY, then press the PRINT button of the station.
LOW BATTERY Battery power is low.
PRESS [EXEC] n Charge the battery (page 18), replace the battery
with a newly charged one (page 19) or use the
camera with the supplied AC adaptor (page 20).
To erase the message and return the LCD to the
normal display, press the EXEC button.
CAMERA ERROR Communication trouble with the camera has occurred.
n Turn off the camera and the printer, then turn them
on again.
Inst SS Ver.4.0
3-865-646-14(1)