Inserting A Battery - Sony UPX-2000 Manual De Instrucciones

Inserting a battery

Notes
• When a fully charged battery pack is installed, the CHARGE lamp will
once light, then go out.
• If the CHARGE lamp does not light or flash, check that the battery pack
is correctly attached to the AC power adaptor/charger. If it is not
attached it will not be charged.
• When charging the battery, disconnect the cable from the DC OUT
connector of the AC power adaptor/charger.
When the CHARGE lamp flashes
Check through the following chart.
Remove the battery pack from the AC power adaptor/charger, then install the
same battery pack again.
If the CHARGE lamp flashes again:
Install another battery pack.
If the CHARGE lamp flashes again:
The problem is with the AC power
adaptor/charger.
Please contact your nearest Sony dealer in connection with the product with
the problem.
1
Open the battery compartment lid on the bottom of the camera.
2
Insert a lithium ion battery.
3
Close the lid.
Inst SS Ver.4.0
If the CHARGE lamp lights and
does not flash again:
If the CHARGE lamp goes out
because the charging time has
passed, there is no problem.
If the CHARGE lamp lights and
does not flash again:
If the CHARGE lamp goes out
because the charging time has
passed, the problem is with the
battery pack first installed.
Lithium ion battery
3-865-646-14(1)
19