Preparations; Preparation Of The Camera; Charging The Battery Pack - Sony UPX-2000 Manual De Instrucciones

Preparations

Preparation of the Camera

Charging the battery pack

18
Charge a lithium ion battery by using the supplied AC power adaptor/
charger.
2
Terminal shutter
1
Connect the AC power cord to the AC power adaptor/charger.
2
Install the battery pack to the AC power adaptor/charger.
Align the end surface of the battery pack shown by the 4 mark to the
edge of the terminal shutter of the AC power adaptor/charger, then fit
and slide the battery pack in the direction of the arrow. Push down
until terminal shutter is covered.
3
Connect the power cord to a wall outlet.
The CHARGE lamp (orange) will light and charging will begin.
When the CHARGE lamp goes out, normal charge is completed
(Normal charge). For a full charge, which allows you to use the
battery longer than usual, leave the battery pack in place for
approximately one hour (Full charge).
Remove the battery pack when required. It can be used even if the
charging is not completed.
To remove the battery pack
Slide it in the direction opposite to the arrow in the above illustration.
3
to AC outlet
AC power cord
1
CHARGE lamp
(orange)
Inst SS Ver.4.0
3-865-646-14(1)