Attach The Patio Panel - Petsafe Freedom Manual De Instalación

Step 3

Attach the Patio Panel

3A Slide the Patio Panel out slightly from door jamb to show pre-drilled
holes in height adjuster. Drill ₇ ⁄ ₆₄" (2.5 mm) holes through the two pre-
drilled holes on interior side of height adjuster. Secure height adjuster
to Patio Panel using two #6 x ½" sheet metal screws. Slide Patio Panel
back against door jamb. Make sure it is flush without any gaps.
Patio Panel Options for Exposed or Recessed
Door Frames
OPTION 1 BELOW IS FOR AN EXPOSED SLIDING GLASS FRAME
INSTALLATION ONLY. IF INSTALLING THE PATIO PANEL INTO A
RECESSED SLIDING GLASS DOOR FRAME, USE OPTION 2.
NOTE: There are two methods of attaching the Patio Panel.
1
With screws (For exposed door frames only)
2
With T-brackets using screws (For exposed or recessed door frames)
Install Patio Panel into an Exposed sliding glass door frame
1
using screws
Prior to installation and drilling, consult your sliding glass door manufacturer's
warranty. Unauthorized changes or modifications may void the warranty. Installing
screws into vinyl door frames or door jambs may crack the vinyl.
3B To install the Patio Panel into an exposed sliding glass door frame,
find the Patio Panel center at the top and mark on the sliding glass door
frame. Measure 12" (30.5 cm) from the top down the side of sliding
glass door frame and mark. Measure 1" (2.5 cm) above the pet door in
the Patio Panel and mark
on the sliding glass door
frame. Measure the center
of the Patio Panel at the
bottom and mark on the
sliding glass door frame.
3C Drill ₉ ⁄ ₆₄" (3.5 mm)
clearance holes through
your sliding glass door
frame ONLY at the
locations you just marked.
DO NOT DRILL INTO
THE PATIO PANEL AT
THIS TIME.
3C
www.petsafe.net
3A
Height
Adjuster
Pre-drilled
Holes
3B
12"
30.5 cm
1"
2.5 cm
7