Install The Boundary Wire; To Bury The Boundary Wire; To Attach The Boundary Wire To An Existing Fence - Petsafe Deluxe PCF-1000-20 Manual De Funcionamiento

Width Control knob clockwise increases
the Boundary Width while turning it counterclockwise decreases it (6B). Repeat
this activity as needed until the Receiver
Collar beeps at the desired distance from the
Boundary Wire.
The numbers on the Boundary Width Control
knob indicate signal strength and are not
representative of Boundary Width footage. If
adjusting the Boundary Width Control knob
does not give the desired range, adjust the Boundary Control Switch to another setting to achieve your desired range. If
using a Double Loop, you may need to increase the separation of the Boundary Wire to achieve desired range.
The Receiver Collar beeps as a warning tone and ticks when delivering a Static Correction. After hearing the beep,
continue to walk towards the wire. The Receiver Collar should tick and the Test Light should fl ash, indicating the
Static Correction as you enter the Static Correction Zone (6F). A warning tone and the fl ashing of the Test Light
indicate that the Receiver Collar and the system are working properly. Test in a number of different areas until you
are satisfi ed that the system is functioning properly. Next, walk all around the Pet Area to ensure there are no areas
where the Receiver Collar may activate from signals coupled onto buried wires or cables. Test the collar in and
around the inside of the house as well. As mentioned, cable and wires from cable TV, electrical or telephone lines
may conduct pet fencing signals inside and outside the house that can activate the cat's collar accidentally. While
rare, if this occurs your Boundary Wire is probably too close to these outside lines and should be moved or modifi ed
as shown in Figure 3A.
If you are satisfi ed that your system is functioning properly, you are ready to start burying the Boundary Wire. If the
Receiver Collar did not beep or the Test Light did not fl ash, see the "Troubleshooting" section.
Note: The Boundary Width is broken down into 20% Warning Zone and 80% Static Correction Zone.
____________________________________________________________________________________________________
Step

Install the Boundary Wire

7

To Bury the Boundary Wire

Burying the Boundary Wire is recommended to protect it and prevent disabling the system.
1. Cut a trench 2.5-7.5 cm (1-3 in.) deep along your planned boundary.
2. Place the Boundary Wire into the trench maintaining some slack to allow it to expand and contract with
temperature variations.
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be careful not to
damage the Boundary Wire insulation.
To Attach the Boundary
Wire to an Existing
Fence
The Boundary Wire of the PetSafe
Ground Cat Fence
to a chain link fence, split rail fence,
or a wooden privacy fence. The
Boundary Wire can be attached as high
as needed. However, make sure the
Boundary Width is set at a high enough
range for your cat to receive the
signal. If using a Double Loop with an
existing fence at least 1m (3 ft) tall, run
the Boundary Wire on top of the fence
and return it on the bottom of the
fence to get the 1 to 1.5 m (3 to 5 ft)
separation needed.
7A
®
In-
™
can be attached
www.petsafe.net
6D
WEAVE WIRE INTO FENCE
STAPLE WIRE TO FENCE
STAPLE WIRE
TO FENCE
6E 6F
Boundary
Wire
7B
SINGLE LOOP
1-1.5 m
(3-5 ft)
DOUBLE LOOP
Boundary
Wire
1-1.5 m
(3-5 ft)
11