Attach The Patio Panel - Petsafe Freedom PPA11-13098 Manual De Instrucciones

Attach the Patio Panel

Step
3
3A
Height
Adjuster
3B
door frame. Measure 12" from the top down the side of sliding glass door frame
and mark. Measure 1" above the pet door in the Patio Panel and mark on the
sliding glass door frame. Measure the center of the Patio Panel at the bottom and
mark on the sliding glass door frame.
3C
3A Slide the Patio Panel out slightly from
door jamb to show pre-drilled holes in height
Pre-drilled
Holes
adjuster. Drill
two pre-drilled holes on interior side of height
adjuster. Secure height adjuster to Patio Panel
using two
Panel back against door jamb. Make sure it is
fl ush without any gaps.
NOTE:
a recessed sliding glass door frame,
12"
contact our Customer Care Center or visit
30.48 cm
www.petsafe.net for a Metal Bracket Kit,
MPA00-12891 and installation instructions.
Prior to installation and drilling, consult your
1"
sliding glass door manufacturer's warranty.
2.54 cm
Unauthorized changes or modifi cations may
void the warranty. Installing screws into vinyl
door frames or door jambs may crack the vinyl.
3B To install the Patio Panel into an exposed
sliding glass door frame, fi nd the Patio Panel
center at top and mark on the sliding glass
www.petsafe.net
7
/
" (2.5 mm) holes through the
64
5
/ " sheet metal screws. Slide Patio
8
If installing the Patio Panel into
NOTICE
3C Drill
9
/ " (3.5 mm) clearance
64
holes through your sliding glass
door frame ONLY at the locations
you just marked. DO NOT DRILL
INTO THE PATIO PANEL AT THIS
TIME.
7