To Attach The Boundary Wire To An Existing Fence - Petsafe PIG19 Manual De Funcionamiento Y De Adiestramiento

To Attach the Boundary Wire to an Existing Fence

The Boundary Wire can be attached to a chain link
fence, split rail fence or a wooden privacy fence. The
Boundary Wire can be attached as high as needed.
However, make sure the Boundary Width is set at a
high enough range for the pet to receive the signal.
If using a Double Loop with an existing fence at least
1.5 m tall, run the Boundary Wire on top of the fence
and return it on the bottom of the fence to get the 1.5 m
separation needed.
• Chain Link Fence (7A): Weave the Boundary
Wire through the links or use plastic quick ties.
• Wooden Split Rail or Privacy Fence (7A):
Use staples to attach the Boundary Wire. Avoid
puncturing the insulation of the Boundary Wire.
• Double Loop with an Existing Fence: Run the
Boundary Wire on top of the fence and return it on
the bottom of the fence to get the 1.5 m separation needed.
• Gate (Single Loop) (7B): Bury the Boundary Wire in the ground across the gate opening. Note: The signal is still active
across the gate. Your pet cannot pass through an open gate.
• Gate (Double Loop) (7B): Bury both Boundary Wires across the gate opening while keeping them 1.5 m apart.
To Cross Hard Surfaces (driveways, sidewalks, etc.)
Follow all safety instructions for your power tools. Be sure to always wear your safety goggles.
• Concrete Driveway or Sidewalk (7C):
Place the Boundary Wire in a convenient expansion
joint or create a groove using a circular saw
and masonry blade. Place the Boundary Wire
in the groove and cover with an appropriate
waterproofing compound. For best results, brush
away dirt or other debris before patching.
• Gravel or Dirt Driveway (7D): Place the
Boundary Wire in a PVC pipe or water hose to
protect the Boundary Wire before burying.
7A
WEAVE WIRE INTO FENCE
STAPLE WIRE TO FENCE
STAPLE WIRE
TO FENCE
7C
www.petsafe.net
7B
SINGLE LOOP
1.5 m 1.5 m
DOUBLE LOOP
7D
17