Working Position; Switch On/Off; Settings; Connecting The Mobile Dust Extractor - Festool KS 60 E Manual De Instrucciones

► Swivel the rotary base into the right-hand
position.
▷ Release the rotary knob [2-6].
▷ Press and hold the detent lever [1-11].
▷ Swivel the rotary base [1-12] as far to
the right as it will go.
▷ Release the detent lever, close the rota­
ry knob.
The machine is in the transport position [6].
The machine has several carrying
handles: Handles on the saw
unit[6-1], in the cord holder [6-3] and
the extension tables [6-2](when they
are securely in place.).
6.4

Working position

Unlock the machine (working position)
► Swivel the saw unit into a vertical position
(saw blade is vertical) [10].
► Push the saw unit downwards as far as the
limit stop and hold it there.
► Pull the lever for the transport locking de­
vice [1-6].
► Slowly guide the saw unit upwards.
► Unwind the mains cable and plug in the
mains plug.
The machine is ready for operation.
6.5

Switch on/off

► Check the electrical safety of the power
connection.
► Move the machine into the working position
or release the lock on the saw unit.
► Press and hold the safety button [1-2].
► Press and hold the On/Off switch [1-3].
Press = ON
Release = OFF
7

Settings

7.1 Electronics
The machine features electronics with the fol­
lowing properties:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel [2-5]. As a result, you can adapt the cut­
ting speed in a way that best suits the relevant
material (see table).
Recommended position of the adjusting wheel
Wood
Plastic
Fibrous material
Aluminium and non-ferrous profiles
Current limiting
Current limiting prevents excessive current
consumption under extreme overload, which
can lead to a decrease in the motor speed. The
motor immediately restarts after the load is re­
moved.
Temperature cut-out
When exceeding a certain engine temperature
level, the machine power supply and speed are
capped. The power tool continues operating at
reduced power to allow the ventilator to cool
the motor rapidly. The power tool resumes to
full performance automatically once the motor
has cooled sufficiently.
7.2

Connecting the mobile dust extractor

WARNING
Dust hazard
► Dust can be hazardous to health. Always
work with a dust extractor.
► Always read applicable national regula­
tions before extracting hazardous dust.
Festool mobile dust extractor
A Festool mobile dust extractor with an extrac­
tor hose diameter of 27 mm or 36 mm (36 mm
is recommended due to the reduced risk of
clogging) can be connected to the extractor
connector [2-2] at the elbow.
7.3 Setting the stop rulers [8]
Moving the stop rulers may make it nec­
essary to implement special settings for
inclined cutting. In the case of inclined cutting,
there is a risk that the stop ruler will be sawed.
► Open the rotary knobs (on both sides) .
► Move the stop rulers [8-3] in such a way
that there is a maximum clearance of 8 mm
from the saw blade.
► While the machine is switched off, lower the
saw unit in a trial run to check whether the
saw blade comes into contact with the stop
rulers.
► Close the rotary knobs.
English
3 - 6
3 - 5
1 - 3
3 - 6
25