Tabla de contenido
22
3.4 Wheel axle securing system
The system for securing the wheel axle to the fork sliders can be
standard, which uses the traditional advanced dropouts, or have a
20 mm diameter through-hole axle or with QR quick release axle.
Forks that are created for more intensive use are provided with
a wheel fastening system, which originates from the motocross
application and uses a 20 mm axle.
The new QR system allows combined hardness and easy
installation.
WHEEL AXLE SECURING SYSTEM WITH STANDARD DROPOUTS
CORSA - MARATHON - 44 - DIRT JUMPER - DJ COMP - TXC
WHEEL AXLE SECURING SYSTEM WITH
20 MM DIAMETER THROUGH-HOLE AXLE
DIRT JUMPER
DJ COMP
WHEEL AXLE SECURING SYSTEM WITH
QR20 QUICK RELEASE AXLE
WHEEL AXLE SECURING SYSTEM WITH
QR15 QUICK RELEASE AXLE
44 - 44 29" - 4X
Table 4 - Wheel securing systems
888 RV
888 (excluding 888 RV)
55 - 66
3.4.1 Wheel installation on a fork with standard securing system
CORSA
MARATHON
DIRT JUMPER
Install the wheel in compliance with the wheel manufacturer's
instructions. For correct fork function after installing the wheel,
you will need to:
•
Check the fork-wheel alignment by fully compressing the fork
a few times. The wheel should not make contact with, or come
close to any portion of the fork.
•
Lift the front of the bicycle, and spin the wheel a few times to verify
correct alignment and spacing with the disk brake or the V-Brake
brake pads. Check the owner's manual of the brake system for
the proper specifi cations.
44
DJ COMP
TXC
Tabla de contenido
