Thermostat For Duct System - Lincar Mya 505 Manual Del Usuario

Electrical rotection device for overcurrent. The appliance is protected against
•
overcurrent by a fuse
For its replacement, contact Technical Service
Shutdown due to overheating. In the event of abnormal heating of the appliance, the
•
security system intervenes and switches off the stove by means of the safety mechanical
Thermostats with manual reset. Thermostats are placed under the cover of the pellet
housing. To reset the thermostats, it is necessary to unscrew the protection cover and
press the thermostat pin. Reset both the Pellet Thermostat and the Chamber
Thermostat.
BE VERY CAREFUL NOT TO LET THE COVER FALL WITHIN THE PELLET
TANK UPON UNSCREWING/SCREWING THE PROTECTION COVER.
The stove can then be switched on again after leaving it to cool for at least 45 minutes.
The persistence of this condition must be verified by the service center or qualified
.
personnel
Pellet Safety
Thermostat
Chamber Safety
Thermostat
THERMOSTAT FOR THE CANALIZATION SYSTEM
It's possible to control the switch on/off of the ventilation for the canalization system.
The appliance is equipped with a second ventilation (Ventilation2) to which is possible to
connect a tube which conveys the hot air produced in an adjacent room.
On the back part of the appliance, there is a
connector to which it's possible to connect a
thermostat/external contact to control the
on/off of the Ventilation2.
Connect to the connector an auxiliary contact
(i,e,. a thermostat / timer) closing the contact,
the Ventilation2 will stop, when the contact is
open the Ventilation2 will function as set ted in
the Menu01.
STAND-BY DUCTING SYSTEM
terminal box
terminal box
(
see technical data) placed on the electronic card.
Ambient
probe
53/128
IT-GB-FR-ES mod. 505
Power feed Serial
cable socket
Open contact
Ventilation2
ON FUNCTION
Closed contact
Ventilation2
ON STOP
Power supply
switch