Torch Handle Control Elements; Trigger Function - Abicor Binzel ABIMIG Serie Instructivo De Servicio

®
ABIMIG

5.9 Torch handle control elements

5.9.1 Trigger function

6 Operation
1 Lay the cable assembly connected to the machine side out straight.
2 Insert the wire into the wire feeder as specified by the manufacturer.
3 Press the 'zero-current wire feed' trigger on the wire feeder until the wire
comes out of the contact tip.
NOTICE
®
• The ABIMIG welding torch must only be operated by qualified
personnel (in Germany, see TRBS 1203).
• Please also consult the operating instructions for the welding
components, welding power source and welding torch.
The trigger's two-cycle mode can be activated when using a standard welding
torch. Further operating modes (e.g. 4-cycle) and torch handle modules
depend on the welding power source and must be ordered separately.
1 Press and hold the trigger on the handle = start welding.
2 Release the trigger = stop welding.
1 Open the shielding gas cylinder.
2 Switch on the power source.
3 Switch on the coolant recirculator for ABIMIG
4 Rinse the shielding gas lines.
5 Start the welding process by pressing and holding the torch trigger.
6 Operation
® ®
W / ABIMIG W T.
EN - 17