Torch Handle Control Elements - Abicor Binzel PP Plus 36D Manual Del Usuario

4 Putting into operation
NOTICE
• Each time the wire is replaced, make sure that the start of the wire is free of burrs and not
bent.
• Make sure that the wire feed roll complies with the diameter of the inserted wire
electrode.
 7.1 Replacing the wire feed roll on page EN-17
1 Insert the wire in the wire feeder as specified by the manufacturer.
2 Open the housing cover (1) at the handle.
3 Unscrew the clamp clip (3) by pressing the pressure adjustment screw (4) upward and
swivel it out laterally.
4 Press the "Current free wire feed" trigger at the wire feeder until the wire comes out of the
contact tip.
5 Lock the clamp clip (3) and close the housing cover (1).
The required contact pressure is pre-set via the pressure adjustment screw (4) or is readjusted
during the welding process.

4.10 Torch handle control elements

NOTICE
• The MIG/MAG welding torch must only be operated by qualified personnel
(in Germany, see TRBS 1203).
• Please also consult the operating instructions for the welding components, welding power
source and welding torch.
Using a standard welding torch, the two-cycle mode of the trigger can be activated. Further
operating modes and handle modules depend on the corresponding welding power supply
and must be ordered separately.
EN - 14
PP Plus 36D/240D/401D
BAL.0140 • 2018-10-15