Replacing Fuses - Testomat EVO TH Serie Manual De Instrucciones

Servicing and maintenance

Motherboard
F6 F1
F4
F5
F3
F2
72

Remove both fixing screws
on the motherboard

Remove the control card

Using a non-conductive tool, carefully prise the used battery out of
its mounting. Avoid damaging the circuit board with the sharp edge
of a screwdriver.

Insert a new battery

Reconstruct the circuit board by following the steps for dismantling
of the same in reverse.

Replacing fuses

Device fuses (internal)
These fuses protect the Testomat
overload and short circuit. All fuses are pluggable.
The main fuses F1 and F6 (4A MT) for outputs and equipment are
located on the motherboard.
The power pack includes the four primary and secondary fuses, F2 to
F5 for 24V and 12V, 3.3V
Circuit board for power pack 230V
24V
Primary F2: 315 mA/T
Secondary F4: 2 A/T

of the upper and lower control card
® EVO TH device or outputs against
12V/3.3V
F3: 160 mA/T
F5: 1.6 A/T