Cable Ducting; Install Power Supply Board And Connect Mains Voltage - Testomat EVO TH Serie Manual De Instrucciones

Dispositivo automático de análisis en línea para dureza total residual (dureza del agua)
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Assembly
!
DANGER
Observe ESD safety
precautions! See the
information on page 8
20

Cable ducting

To guarantee IP protection, the device is supplied with cable ductings
and blanking plugs. If you wish to use a relay output, you must re-
move the blanking plug from the cable ducting.
Proceed as follows in this instance:
Loosen the strain relief of the cable ducting (union nut).
Take out the blanking plug and insert the cable.
Tighten the union nut of the cable ducting and so establish the
strain relief.
Install power supply board and connect mains
voltage
Installing the terminal compartment cover
For technical safety reasons, the terminal compartment cover must
be put back in place immediately after connecting the mains voltage
and the system components, since the terminal space houses cables
that carry dangerous voltages. This helps prevent inadvertent contact
with the terminals and contact between the individual lines that may
carry different voltages and thus avoid the risk of a life-threatening
electric shock.
Also ensure that the cable is not pinched when installing the
terminal compartment cover!
Connect the device only to the mains voltage for which it is designed.
See type plate to confirm the suitable mains voltage. To connect the
cable, please proceed as described below:
Remove both fixing screws
Remove the power supply board from the box at the bottom of the
housing.
Insert the power supply board into the slot on the mainboard.
Screw in the two fastening screws at the top and bottom of the
mainboard.
Remove the fixing screws of the terminal cover and then remove
the terminal cover itself.
Lay the cable through the cable ducting provided for that purpose.
Tighten the union nut of the cable ducting and so establish the
strain relief.
Connect the supply voltage to the terminals PE,N,L or, for 24 V
devices, to U and V terminals.
Ensure that the cores in the terminals are securely in place.
Install the terminal compartment cover.
and open the upper door.
Tabla de contenido
loading

Este manual también es adecuado para:

Evo th 2005Evo th 2025Evo th 2100Evo th 2250

Tabla de contenido