Idiomas disponibles
Idiomas disponibles
GB MT
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. The charge status is now shown by the
battery symbol at the top right.
4. Press the START button (3) and close
the cover (1) again. The lawn mower
resumes its previously interrupted activi-
ty.
It is also possible to read the charge
level without unlocking the display,
but it is easier when the display is un-
locked.
Cleaning/maintenance/
storage
Have any work that is not
described in these instruc-
tions performed by an authorised
customer service centre. Only use
original parts.
Before any maintenance or clean-
ing work, switch off the device and
wait for the blades to come to a standstill.
Wear gloves when handling the
blades.
General cleaning and
maintenance work
Never spray down the lawn
mower with water. There is a
risk of electric shock.
• Keep the device clean. Use a brush or
cloth for cleaning, but do not use any
aggressive cleaning agents or solvents.
• Oil the wheels from time to time.
• Check the covers and protective devic-
64
es for damage and correct fi t. Replace
these if necessary.
Replacing the battery
(Fig
)
When replacing the battery: Switch
off the device and wait for the
blades to come to a stop. There is a risk of
personal injury.
There is a risk of injury from leak-
ing battery fl uid if the battery is
damaged! In case of contact with eyes or
skin, rinse the affected sites with water or
a neutralizer and seek medical attention.
1. Turn the lawn mower over.
2. Open the battery compartment (31) by
removing the 4 screws on the under-
side of the device.
3. Remove the battery (32).
4. Insert a new battery.
5. Close the battery compartment (31)
again.
Turning/replacing the blades
(Fig
)
The lawn mower is equipped with reversi-
ble blades. If the blades are blunt on one
side, they can be turned over. If the blades
are damaged or show signs of imbalance,
they need to be replaced (see "Spare
parts/accessories").
1. Turn the device over.
2. Remove blade bolts (19) on the under-
side of the device.
Turning the blades
3. Turn the blades (20) over.
4. Refasten blades with the blade bolts
(19).
