Idiomas disponibles
Idiomas disponibles
GB MT
1. Place the mower on the target area of
the lawn.
2. If necessary, open the cover (1).
3. Unlock the display (10) with the 4-digit
PIN.
4. Press the OK button (7) to enter the
main menu.
5. Select "Spot mode" with the arrow but-
tons (6).
The display shows "Close the cover to
start".
6. Close the cover (1) and the mower
starts mowing with the fixed point.
The lawn mower mows in an anti-
clockwise spiral direction and
switches to "Automatic mowing" after a
mowing radius of 1 m or 3.5 minutes of
mowing.
If the mower encounters an obstacle, the
mower stops, the display indicates that
mowing has stopped and the mower
switches to standby mode.
When the lawn mower hits the boundary
wire (11), it continues mowing in the oppo-
site spiral direction.
If the mower is outside the bounda-
ry wire (11) or on the charging sta-
tion and you select "Spot mode", the dis-
play shows "Please place inside the
boundary and try again". Set the mower
down inside the boundary wire (11) and
next to the charging station and restart
"Spot mode".
If the battery charge level is less
than 30 %, the display shows "Low
battery voltage" after 2 seconds. Charge
the lawn mower before you can start mow-
ing with the fixed point.
54
Setting the rain sensor
Never operate the lawn
mower during storms and
make sure to disconnect the charg-
ing station from the mains.
If the rain sensor is switched on, the lawn
mower returns to the charging station when
it rains. The rain sensor is always activated
in the delivery state.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN.
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confirm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select
"Rain mode".
7. Confirm the selection with the OK but-
ton (7).
8. To deactivate the rain sensor, select
"Deactivate" and confirm the selection
with the OK button (7).
To activate the rain sensor, select "Acti-
vate" and confirm the selection with the
OK button (7).
Select a time in minutes when
the lawn mower should start op-
erating again after the rain.
Decide also whether the lawn mower
should make up for the break in operat-
ing time caused by the rain.
Confirm each selection with the OK
button (7).
9. Return to the main menu with the back
button (5).
We advise against having the lawn
mower operate while it is raining.
