Idiomas disponibles
Idiomas disponibles
If a malfunction appears in the dis-
play during manual mowing and
you are able to rectify and acknowledge it,
the mower will start automatically within
30 seconds after closing the cover (1).
Scheduled mowing
Prerequisites for starting "Sched-
uled mowing" mode:
-
The mower must be in standby mode
to start automatic mowing (see sec-
tion "Switching on and off", section
"Switching on the mower").
Starting from the charging station
-
requires a battery capacity of 100%.
Otherwise, the mower automatically
switches to charge mode until the ca-
pacity is 100%, then it automatically
leaves the charging station.
-
Starting outside the charging station
and inside the boundary wire requires
a battery capacity of more than 30%.
If the battery capacity is less than or
equal to 30%, the mower automatically
returns to the charging station.
1. Close the cover (1).
The mower starts automatically from
standby at the scheduled time programmed
in the schedule (see section "Setting the op-
erating times") when the start requirements
are met.
Do not press the START button in addition,
otherwise the mower will operate in manu-
al mode and not on schedule.
If the STOP button (9) is pressed in
this mode, the message "Emergency
stop" appears in the display followed by
the message "Continue work?". Confirm
with the OK button (7) to start mowing
again or end mowing by pressing the Back
button (5). Mowing will not resume until
the next programmed start time is reached
and the start conditions are met, or when
you start manual mowing.
If a fault is displayed in the mode,
you can rectify and acknowledge it.
The mower starts automatically within 30
seconds after closing the cover (1).
Back to the charging station
When the unit is in standby mode, press
and hold the HOME button (4) for about
3 seconds. The display (10) shows "Close
the cover to start". Close the cover (1) and
the mower moves to the charging station. It
then begins to charge there.
Settings
(Fig
)
The lawn mower has the following setting
options that you can make via the control
panel if you want to change the factory
settings.
GB MT
57
