Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
8.1.7
Micromotor BLDC - DX, DX BLUE, DX PRO
24.AUG
> 1000
> 5000
ENDODONCY
DR.SMITH
After the instrument has been taken the data on its setting is displayed. Its meaning is as follows:
Instrument type
If the bargraph is inactive, it displays the type of the instrument being used.
Bargraph in active condition displays graphically an informative value of the main parameter (power output).
Buttons of the fast pre-selection of the motor rotations.
Press the respective button to change the setting of the output (rotations) to the said value. The data is not
saved automatically into the program memory.
Button for setting the motor rotations.
Press the button to start the setting mode in which the buttons whose values can be changed are displayed
in red. Change the parameter by means of the buttons +/- .
The new value is saved temporarily (until the change of the program number) by pressing the button of the
parameter being set again or permanently into the program by means of the button
entered also directly via numerical keyboard after pressing the button
Button for the selection of a program.
Press the button to display a pop-up menu with program options.
Press the respective button to select the desired program or cancel selecting a program by means of the button ESC
To save all changed and unsaved parameters of instrument settings to program memory, just keep the button pressed
for a longer time (approximately 2 seconds)
The save is indicated by changed color of the icon (to red) and by sound signal (2 short beeps).
After the sound beeping, all data from temporal memory are written to permanent memory.
Button to assign program for switching from foot controller
By pressing on appropriate program, the program is included
via foot controller side button.
If the foot controller function P# has been chosen, then by repeated pressing of this button, all the included
programs are being switched cyclically towards sequentially higher program number. After the included program
UM_EN_TYGI350B_2018-09_ver1.0
12:12
BLDC MOTOR
> 20000
PROGRAM 1
P1
1:1
NORM
AFt
40 000
> 40000
3.5 Ncm
3.0s
33%
or excluded
TYGI 350 B
X1/min
TYGI 350 B
. The new value can be
from programs switching
27 / 49
Capítulos
