Idiomas disponibles
Idiomas disponibles
Transport of batteries
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
Running speed suddenly
drops considerably.
The saw blade stalls.
The motor has no braking
effect.
Cutting angles are inaccurate. The angular accuracy, the scales
LEDs of the battery show
nothing
22
English
Possible cause
Battery is discharged.
Saw advance pressure is too high.
Saw advance pressure is too high.
Battery is discharged.
or the pointers are maladjusted.
Battery defective
Action to be taken
▶ Charge the battery.
▶ Reduce advance pressure and
switch the power tool back on.
▶ Reduce advance pressure and
switch the power tool back on.
▶ Charge the battery.
▶ Check and adjust the settings
and indicators. → page 19
▶ If you cannot adjust a setting
yourself or the saw's accuracy
is too badly off, consult Hilti
Service.
▶ Contact Hilti Service.
2395173
*2395173*
