Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces of the parts of the guard.
4. Install the saw blade. → page 13
7.2
Cleaning dust removal adapter and connecting hose
1. Remove the dust bag or disconnect the suction hose of the dust extractor.
2. Slacken the securing screw of the connecting hose on the saw head (1).
3. Disconnect the connecting hose from the saw head (2) and from the dust removal adapter.
4. Empty the connecting hose and clean it with a dry brush.
5. Clean the chip ejector channel on the saw head and the dust removal adapter with a dry brush.
6. Reconnect the connecting hose to the dust removal adapter and the saw head.
7. Tighten the securing screw of the connecting hose on the saw head.
8. Install the dust bag or reconnect the dust extractor. → page 12
7.3
Emptying dust bag
1. Disconnect the dust bag from the intake adapter.
2. Open the zip fastener of the dust bag and dispose of the contents correctly.
3. Close the zip fastener of the dust bag.
4. Reinstall the dust bag on the dust removal adapter. → page 12
7.4
Checking and adjusting settings and indicators
The dual-bevel compound sliding miter saw was carefully set up and adjusted before it left the factory.
However, after intensive use or rough treatment it might be necessary to check the saw's settings and
indicators and make adjustments as required.
Experience and special tools are necessary for checking and adjusting the saw.
Hilti recommends having the saw adjusted only by Hilti Service.
When performing checking and adjustment work with the angle gauge, do not touch the tips of the
saw teeth with the gauge. This would result in incorrect measurement. The angle gauge must always
be matched to the saw blade disc.
7.4.1
Checking bevel angle
1. Push the saw head all the way back (away from you).
2. Position the stop plate of the depth gauge so that the depth gauge passes through the opening when
the saw head is lowered. → page 13
3. Set the miter angle to 0°.
4. Push the saw head down and engage the transport lock to lock the saw head.
5. Set the bevel angle to 0°.
6. Set an angle gauge to 90°.
7. Set the angle gauge upright and flush on the saw table.
8. Move the angle gauge to the saw blade.
▶ The angle gauge must be flush with the saw blade along the entire line.
9. Set the bevel angle to 45° right.
10. Set the angle gauge to 45° (alternatively, 135° for measurement from the left side).
11. Set the angle gauge upright and flush on the saw table.
12. Move the angle gauge to the saw blade.
▶ The angle gauge must be flush with the saw blade along the entire line.
13. Repeat the steps for the 45° left bevel angle.
Result 1 / 2
The angle gauge is flush with the saw blade along the entire line in all three measurements.
▶ The saw is correctly adjusted.
Result 2 / 2
The angle gauge and the saw blade are not flush in one or more measurements.
▶ Contact Hilti Service.
7.4.2
Adjusting pointers for bevel angle
1. Check that the bevel angle is perfectly accurate. → page 19
*2395173*
18
19
2395173
17
English
19
Tabla de contenido
