Angelo Po 08WFA4G Manual De Uso E Instalación página 41

Idiomas disponibles
  • ES

Idiomas disponibles

TROUBLESHOOTING
The appliance has been tested before being put into
service. The information provided below is intended
to assist in the identification and correction of any
anomalies and malfunctions which might occur du-
ring use. The user can solve some of these problems
himself, but for others specific technical knowledge
or skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Fault
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
The pilot light ignites but the
burner remains off.
The flame is yellow.
Burner control knob is stiff.
FAULT
For all requirements contact the agents or
the headquarters of Angelo Po which can
be found in the contacts section of the web-
site http://www.angelopo.com.
Causes
Occasional leak because
flame has gone out.
The spark ignition devices
are not working.
Air in pipelines due to long period
out of use.
The thermocouple has not
warmed up enough.
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.
- 13 -
Important
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order.
Light by hand with a
naked light.
Important
Contact the after-sales
service
Make more attempts to
light the flame.
Make more attempts to
light the flame.
Check the condition of the
thermostat and activate any
ignition enabling device.
Important
Contact the after-sales
service
Important
Contact the after-sales
service
6
Remedies
English
IT
GB
DE
FR
ES
loading

Este manual también es adecuado para:

12wfa6g