DeLonghi ELETTA EXPLORE ECAM45X8Y Instrucciones De Uso página 25

Ocultar thumbs Ver también para ELETTA EXPLORE ECAM45X8Y:
Idiomas disponibles

Idiomas disponibles

Please note:
The filter lasts about two months if the appliance is used normally.
If the machine is left unused with the filter installed, it will last a
maximum of 3 weeks.
5. Press "Next" to continue ("Back" to go back to the previous
screen; "X" to cancel the operation);
6. To activate the filter, run tap water through the hole in the
center of the filter until water comes out of the openings at
the side for more than a minute (fig. 46). Press "Next";
47
7. Extract the water tank (A23) (fig. 2) and fill with water; in-
sert the filter in the water tank and immerse it completely for
about ten seconds, sloping it and pressing it lightly to enable
the air bubbles to escape (fig. 47). Press "Next";
8. Insert the filter in the filter housing (fig. 48) and press as far
as it will go; press "Next";
9. Close the tank with the lid (A22), then put the tank back in
the machine.
10. Insert the hot water spout (D6). Press "Next";
11. Position an empty container with a minimum capacity of
16.90 fl oz / 0,5 liters under the hot water spout (fig. 6) and
press "Next" to activate the filter;
12. The appliance delivers hot water, then stops automatically.
Press "OK" to go back to the homepage;
13. The filter is now active and you can use the coffee machine.
19.2 Replacing or removing the filter
Replace the filter (D4) when the replace filter message appears
on the homepage (C). To replace the filter immediately, press "OK"
and follow the instructions from point 3 of the previous section. To
replace the filter later, press "Cancel". The filter symbol appears on
the display to remind you the filter needs replacing.
To replace, proceed as follows:
1. Press the settings menu (C3);
2. Scroll through the pages until "Water filter" is displayed, then
press "OK";
3. Press "OK" to enter the guided procedure;
4. Extract the water tank (A23) and exhausted filter.
5. To remove the filter, press "OK" ("Back" to go back to the pre-
vious screen; "Cancel" to cancel the operation);
6. To replace the filter, press "Next" and follow the operations
described in the previous section from point (4).
Please note:
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if the
message has not yet been displayed.
20. TIPS FOR ENERGY SAVING
To reduce energy consumption, after delivering one or more
drinks, remove the milk carafes or accessories.
Set auto-off to 15 minutes (see section "7.8 Set auto-off");
Enable Energy Saving (see paragraph "7.9 General");
Always carry out the descaling cycle when prompted by the
machine.
21. REGULATORY COMPLIANCE (CONNECTED
MODELS ONLY)
FCC for USA
48
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable
protec-tion against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the in-structions, may cause harmful interference to radio
communica-tions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
IC for CND
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two con-
di-tions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that
may cause undesired operation of the device.
25
loading

Este manual también es adecuado para:

Eletta explore ecam45086s