Replacingthe Filter; Removing The Filter - DeLonghi ELETTA CAPPUCCINO EVO ECAM4686X Manual De Instrucciones

Please note
The filter lasts about two months if the appliance is used nor-
mally. If the coffee maker is left unused with the filter installed,
it will last a maximum of three weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in fig. 35 until water comes out of the open-
ings at the side for more than a minute;
36
4. Extract the tank (A14) from the appliance and fill with
water;
5. Insert the filter in the water tank and immerse it complete-
ly for about ten seconds, sloping it and pressing it lightly to
enable the air bubbles to escape (fig.36);
6. Insert the filter in the filter housing (A15) and press fully
home (fig. 37);
7. Close the tank with the lid (A13) (fig. 38), then replace the
tank in the machine;
8. When you install the filter you must notify the appliance
of its presence.
9. Press (B2) to enter the "Settings" menu;
10. Press the scrolling arrows
"Maintenance" is displayed, then press
11. Press the scrolling arrows until "Install filter" is displayed,
then press ;
12. Press to confirm;
37
38
(B3) or (B10)until
(B11);
19
13. Place an empty container with a minimum capacity of 500
ml under the hot water spout (C6), then press
start delivery;
14. The appliance starts delivering water;
15. After the flow of hot water stops, the appliance automati-
cally reverts to ready for use again.
The filter is now active and you can use the coffee machine.

14.2 Replacingthe filter

Replace the filter (C4) when requested by the appliance. To re-
place immediately, press
tions from point 8. To replace the filter later, press
The symbol appears on the display (B1) to remind you that the
filter needs replacing.
To replace, proceed as follows:
1. Extract the tank (A14) and exhausted filter;
2. Take the new filter out of its packet and proceed as illus-
trated in points 2, 3, 4, 5, 6 and 7 in the previous section;
3. Press to enter the "Settings" menu;
4. Press the scrolling arrows
"Maintenance" is displayed, then press
5. Press the selection arrows until "Replace filter" is dis-
played, then press
6. Press to confirm;
7. Place an empty container with a minimum capacity of 500
ml under the hot water spout (C6), then press
8) to start delivery;
8. After the flow of hot water stops, the appliance automati-
cally reverts to ready for use again.
The new filter is now active and the coffee machine can be used.
Please note:
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the filter even if
the message has not yet been displayed.

14.3 Removing the filter

If you want to use the appliance without the filter (C4), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A14) and exhausted filter;
2. Press (B2) to enter the "Settings" menu;
3. Press the scrolling arrows
"Maintenance" is displayed, then press
4. Press the scrolling arrows
filter" is displayed, then press
5. Press to confirm removal. The appliance goes back
to the previous screen;
6. Then press twice to exit the menu.
(B11) and follow the instruc-
(B3) or (B10) until
;
;
(B3) or (B10)until
(B11);
or until "Remove
;
to
(B2).
(fig.